This product is specifically designed to protect petrol and LPG engine parts against wear and restore worn petrol and LPG engines without disassembly. It forms a strong new ceramic-metal bond with metal that smooths and restores the part surface and optimizes tolerances for 100000km.

Advantages

• Restores and protects metal-to-metal surfaces of the cylinder-piston group, crank and gas distributing parts against wear;
• Reduces fuel consumption (by up to 30% at idling);
• Increases oil pressure to the nominal one;
• Restores compression in cylinders;
• Increases engine power;
• Improves acceleration capability;
• Decreases noise and vibration;
• Extends service life of the engine parts ( up to 2-3 times longer);
• Improves cold starts and protects the engine against their negative consequences;
• Shows noticeable improvement within 75 - 100 miles

Technical characteristics

• General characteristics of the cermet layer:
• Microhardness – 750 kg/mm2;
• High corrosion resistance;
• Roughness Ra up to 0.06 mkm.

Certificates

This product complies to the following standards:

• ISO6244
• ASTM D 941, D 1298, D 1481
• ISO 8781
• ASTM D 1743
• ISO 3733

Certificate available for download as Adobe PDF file
Download certificate

Instructions

Complete Engine Treatment (3 tubes are required)

• Step 1
  Warm engine for 10 - 15 minutes.
  Add 1 x 9ml tube of Petrol/LPG Engine Treatment (red tube) to engine oil.
  
  Start the engine and let it idle for 5-10 minutes.
  Drive as usual for 150-250km or idle your car for 4 hours.
   
• Step 2
  Warm engine for 10 - 15 minutes.
  Add 1 x 9ml tube of Petrol/LPG Engine Treatment (red tube) to engine oil.

  Start the engine and let it idle for 5-10 minutes.
  Drive as usual for 150-250km or idle your car for 4 hours.
   

• Step 3
  Warm engine for 10 - 15 minutes.
  Add 1 x 9ml tube of Petrol/LPG Engine Treatment (red tube) to engine oil.

  Start the engine and let it idle for 5-10 minutes.
  Drive as usual for 150-250km or idle your car for 4 hours.

  Engine treatment considered complete after 1500km of run. Do not change engine oil until then.
   

High kilometer Restoration Treatment (4 tubes are required )

• Step 1
  Warm engine for 10 - 15 minutes.
  Add 2 x 9ml tubes of Petrol/LPG Engine Treatment (red tube) to engine oil.

  Start the engine and let it idle for 5-10 minutes.

• Step 2
  Warm engine for 10 - 15 minutes.
  Add 2 remaining 9ml tubes of Petrol/LPG Engine Treatment (red tube) to engine oil.

  Start the engine and let it idle for 5-10 minutes

Brand new vehicles Treatment

• One Step Process 
  Warm engine for 10 - 15 minutes.
  Add 2 x 9ml tubes of Petrol/LPG Engine Treatment (red tube) to engine oil.
  Start the engine and let it idle for 5-10 minutes.

Note!

• Do not change oil for 1500 kilometers, when treatment process is complete.
• The protective cermet coating forms on any operative mechanism with no effect on seals or gaskets.
• If the engine is in critical state, worn parts must be replaced.